This summer is good for the computer to cool off!

As we all know, Nanjing has the name "fire stove." When the temperature reaches another year, not only people will suffer from heat stroke, but the computers we use every day will also suffer from heat stroke. They are slow to run, crash, crash, or even burn hardware. Today, Xiaobian explains to you five ways to relieve the heat of your computer:

First. Correct placement

Use computers in the summer to put the chassis or monitor in a ventilated environment. If possible, use a computer in an air-conditioned room. The computer must be placed against a wall, and no heat-generating appliances should be placed around it. When placing the host, choose a location that is conducive to air circulation. The space around the top of the chassis must have a certain amount of space. Pay special attention to the air inlets and exhaust ports on the chassis to make sure that the airflow is not blocked.

Second, pay attention to dust

Almost everyone knows that dust can lead to poor heat dissipation, so our first thing to do is to remove dust from all parts! Although simple, you should pay attention to the following three issues when you want to achieve a good dust removal effect.

1. We want to use the kind of white fur brush, first brush the dust off the various radiators such as cards and fans (do not use a toothbrush).

2. After using the brush, be sure to use a blower or use a high-pressure air gun to inflate the bicycle against each card and fan and various radiators. After blowing it, you will find it clean and a lot of...

3. When inserting the card, it is necessary to clean the slots first with a small brush to ensure that the slots are clean. Otherwise, it may cause unnecessary dust due to accidentally falling dust in the slots. Trouble, and be sure to be careful when you return the fans to avoid human failure.

Third, control the length of use

Use computers in the summer must pay attention to mastering the time. Minimize the use of computer time, continuous use of the best control within 5 hours. At the same time, between the two boot, the best interval of 1 hour or more, let the computer take a cool break.

Fourth. Reasonable system settings

It is best to turn off the computer when not in use, because when using the screen saver, the power of the computer is not much lower than usual, and the heat can not be ignored. The computer is best set to sleep mode after being idle for 15-20 minutes. These measures can save energy and extend the life of the computer.

Fifth. Installing a heat sink

Most chassis are provided with cooling fan installation positions on the front panel and rear panel, and a cooling fan of an appropriate size is purchased for installation. The front fan is used as an air inlet, and cool air is introduced into the interior of the chassis. The rear fan is used as an exhaust outlet. It allows convection inside the entire chassis, which is very beneficial for heat dissipation of the motherboard and other accessories. Large diameter fans and low speeds also ensure a large amount of air flow. For student families that do not have air-conditioning in their dorms or use laptops, the dedicated radiators for notebooks are the best choice for heat dissipation. The introduction of cold air, heat flow, increase the air circulation at the bottom of the notebook to achieve the effect of lowering the temperature.